Laser marking machine frequency: the number of pulses per unit time is called the fiber laser marking machine marking frequency.
This is a good understanding. Marking frequency, then the laser point on the dense, small marking frequency, the laser point is loose. Although the naked eye may not feel out, but if we place the marking under the electron microscope, we can see after amplification, in the eyes is a continuous straight line is actually composed of many points. The larger the marking frequency, the more intense the laser spot, the smoother the marking area.
Laser marking machine speed: This refers to the laser scanning galvanometer speed.
This speed refers to the speed that can be adjusted in the parameter, not the overall speed of marking a product. Because the overall marking speed not only by the speed adjustment parameters, but also by the marking depth, marking area and other factors. Marking the role of this parameter is the role of other conditions in a constant, faster, faster marking speed. Fast, the same place less the number of laser strikes. Slow, it is more conducive to playing depth. But not the slower the slower the better. Because the marking time is too slow, the material hit by the laser will accumulate on the surface of the material, affecting the laser hit deeper. So if it is playing deep, then use low-speed play several times after using high-speed sweep again.
Laser marking machine power: In the parameter settings, the power is adjusted as a percentage, from 0% to 100% of the output power can be adjusted.
The default default is 50% of the output power. The greater the output power adjustment, the greater the laser output energy, the easier it is to hit the depth. However, the output power is much larger according to their actual needs of choice, because the output energy is too large, the greater the impact on the material to achieve the effect you want, you can not open a greater power, or a long time high load Work, then, the life of the laser will have an impact. Filling, mainly used in the closed graph of unrelated.
Filling types are: Unidirectional fill, Bidirectional fill, Ring fill, and Optimized bi-directional fill, to adjust fill angle and line spacing, line margin. Nothing to say about this parameter, we actually try to know what is going on (in the graphics fill lines).
Pulse width of laser marking machine: Pulse width refers to the duration of a pulse. General fiber laser marking machine does not regulate the pulse width function, pulse width adjustable fiber laser marking machine what are the advantages of it, the main is that you can use to fight the black aluminum oxide, and in depth will have a little advantage.